Fiat · Linea · 2007-2016
Fiat Linea 1.3 Multijet 95 specs and common problems
Before the Egea, one of Turkey's best-selling sedans. The chain-driven 1.3 Multijet is economical. The best-known problems are the Dualogic robotised gearbox, DPF clogging on DPF-equipped cars and chain stretch at high mileage.
01 / 07
How much oil does the Linea 1.3 Multijet 95 take?
The Linea 1.3 Multijet 95 takes about 3.9 litres of 5W-30 engine oil including the filter. Approval to look for on the bottle: Fiat 9.55535-S1 / ACEA C2.
- Approval
- Fiat 9.55535-S1 / ACEA C2
- Alternative
- 0W-30
- Manual 5-speed
- 75W-85 · ≈ 1.8 L
- Dualogic robotised
- Manual gearbox oil + Dualogic hydraulic fluid · ≈ 1.8 L
- Coolant
- Paraflu (OAT) 50/50 · ≈ 6 L
- Brake fluid
- DOT 4
The value may vary by engine version; check with the dipstick.
02 / 07
Timing chain and maintenance
No replacement interval; replaced when stretch symptoms appear
A rattle on cold start signals chain stretch.
- Oil change
- 15,000 km or once a year (10,000 km with DPF)
- Glow plug
- 4 pcs · When they fail
- Valves / tappets
- Hydraulic tappets.
- Fuel filter
- 30,000 km
- Power
- 95 hp @ 4,000 rpm
- Torque
- 200 Nm @ 1,500 rpm
- Displacement
- 1,248 cc
- Fuel
- Diesel · Variable geometry turbo, intercooler
- Valvetrain
- DOHC 16V
- Injection
- Common-rail direct injection
- Transmission
- 5-speed manual / 5-speed Dualogic robotised
- Emissions
- Euro 5 (DPF)
03 / 07
Tyre size and pressure
- Original size
- 185/65 R15
- Alternative sizes
- 205/55 R16 · 205/50 R17
- Bolt pattern (PCD)
- 4x98
- Centre bore
- 58.1 mm
- Wheel
- 6J x 15
04 / 07
Is the Linea 1.3 Multijet 95 suitable for LPG?
- Classic LPG conversions are not done on diesel engines.
05 / 07
Linea 1.3 Multijet 95 common problems and fixes
- #01
Dualogic transmission failure
High RiskAfter 80,000 km
- Symptom:
- Won't engage gear, N flashing on the display, harsh and delayed shifts.
- Cause:
- Hydraulic pump, accumulator or actuator failure; clutch wear.
- Proper fix:
- Hydraulic unit repair, clutch replacement and bite-point relearn.
- #02
DPF clogging
High RiskAfter 60,000 km
- Symptom:
- DPF warning, loss of power, oil level rising.
- Cause:
- Short trips.
- Proper fix:
- Motorway driving or service regeneration, DPF cleaning if needed.
- #03
Timing chain stretch
High RiskAfter 180,000 km
- Symptom:
- Rattle when cold, hard starting, P0016.
- Cause:
- Long oil change intervals.
- Proper fix:
- The chain kit and tensioner are replaced.
06 / 07
Common fault codes on the Linea 1.3 Multijet 95
- P2002Diesel Particulate Filter Efficiency Below Threshold (Bank 1)
- P0401Exhaust Gas Recirculation Flow Insufficient Detected
- P0087Fuel Rail/System Pressure - Too Low
- P0380Glow Plug/Heater Circuit A Malfunction
- P0016Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor A)
- P0700Transmission Control System Malfunction
07 / 07
Frequently asked questions
How much engine oil does the Linea 1.3 Multijet 95 take?
The Linea 1.3 Multijet 95 (1.3 Multijet) takes about 3.9 litres of engine oil including the filter. Recommended viscosity is 5W-30; look for the Fiat 9.55535-S1 / ACEA C2 approval. Check the level on the dipstick after filling.
When should the timing chain on the Linea 1.3 Multijet 95 be replaced?
This engine uses a timing chain. No replacement interval; replaced when stretch symptoms appear. A rattle on cold start signals chain stretch.
What tyre pressure should the Linea 1.3 Multijet 95 run?
With the original 185/65 R15 tyres, 33 PSI front and 33 PSI rear are recommended at normal load, and 36 front / 39 rear at full load. The exact values are on the door pillar or fuel flap sticker.
Is the Linea 1.3 Multijet 95 suitable for LPG?
Not suitable, diesel engine. Classic LPG conversions are not done on diesel engines.
What are the common problems of the Linea 1.3 Multijet 95?
The best-known problems are: Dualogic transmission failure, DPF clogging, Timing chain stretch. The symptoms and fix for each are explained on this page.
Other Fiat models
Values are approximate and may vary by engine and VIN. Check against your service manual before doing any work. ·