Fiat · Egea (356) · 2015-2020
Fiat Egea 1.3 Multijet 95 specs and common problems
Built in Turkey and for years the country's best-selling sedan. The 1.3 Multijet is an economical engine with a timing chain. The most common complaints are DPF clogging, EGR and chain stretch at high mileage.
01 / 07
How much oil does the Egea 1.3 Multijet 95 take?
The Egea 1.3 Multijet 95 takes about 3.9 litres of 0W-30 engine oil including the filter. Approval to look for on the bottle: Fiat 9.55535-DS1 / ACEA C2.
- Approval
- Fiat 9.55535-DS1 / ACEA C2
- Alternative
- 5W-30 (DPF-compatible, Fiat-approved)
- Manual 5-speed
- 75W-80 / 75W-85 · ≈ 1.8 L
- Coolant
- Paraflu (OAT) 50/50 · ≈ 6 L
- Brake fluid
- DOT 4
The value may vary by engine version; check with the dipstick.
02 / 07
Timing chain and maintenance
No replacement interval; replaced when stretch symptoms appear
At high mileage, a rattle on cold start signals chain stretch.
- Oil change
- 15,000 km or once a year (10,000 km in the city)
- Glow plug
- 4 pcs · When they fail
- Valves / tappets
- Hydraulic tappets.
- Fuel filter
- 30,000 km
- Power
- 95 hp @ 3,750 rpm
- Torque
- 200 Nm @ 1,500 rpm
- Displacement
- 1,248 cc
- Fuel
- Diesel · Variable geometry turbo, intercooler
- Valvetrain
- DOHC 16V
- Injection
- Common-rail direct injection
- Transmission
- 5-speed manual
- Emissions
- Euro 6 (DPF)
03 / 07
Tyre size and pressure
- Original size
- 195/65 R15
- Alternative sizes
- 205/55 R16 · 215/45 R17
- Bolt pattern (PCD)
- 4x98
- Centre bore
- 58.1 mm
- Wheel
- 6J x 15
04 / 07
Is the Egea 1.3 Multijet 95 suitable for LPG?
- Classic LPG conversions are not done on diesel engines.
05 / 07
Egea 1.3 Multijet 95 common problems and fixes
- #01
DPF clogging
High RiskAfter 60,000 km (earlier in the city)
- Symptom:
- DPF warning, loss of power, oil level rising.
- Cause:
- Regeneration being interrupted on short trips.
- Proper fix:
- Motorway driving or service regeneration, DPF cleaning if needed.
- #02
EGR valve failure
Medium RiskAfter 80,000 km
- Symptom:
- Rough idle, limp mode, P0401.
- Cause:
- Soot build-up.
- Proper fix:
- EGR cleaning or replacement.
- #03
Timing chain stretch
High RiskAfter 180,000 km
- Symptom:
- Rattle when cold, hard starting, P0016.
- Cause:
- Long oil change intervals and a worn tensioner.
- Proper fix:
- The chain kit and tensioner are replaced.
06 / 07
Common fault codes on the Egea 1.3 Multijet 95
- P2002Diesel Particulate Filter Efficiency Below Threshold (Bank 1)
- P0401Exhaust Gas Recirculation Flow Insufficient Detected
- P0299Turbocharger/Supercharger A Underboost Condition
- P0087Fuel Rail/System Pressure - Too Low
- P0380Glow Plug/Heater Circuit A Malfunction
- P0016Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor A)
07 / 07
Frequently asked questions
How much engine oil does the Egea 1.3 Multijet 95 take?
The Egea 1.3 Multijet 95 (1.3 Multijet II) takes about 3.9 litres of engine oil including the filter. Recommended viscosity is 0W-30; look for the Fiat 9.55535-DS1 / ACEA C2 approval. Check the level on the dipstick after filling.
When should the timing chain on the Egea 1.3 Multijet 95 be replaced?
This engine uses a timing chain. No replacement interval; replaced when stretch symptoms appear. At high mileage, a rattle on cold start signals chain stretch.
What tyre pressure should the Egea 1.3 Multijet 95 run?
With the original 195/65 R15 tyres, 33 PSI front and 33 PSI rear are recommended at normal load, and 36 front / 39 rear at full load. The exact values are on the door pillar or fuel flap sticker.
Is the Egea 1.3 Multijet 95 suitable for LPG?
Not suitable, diesel engine. Classic LPG conversions are not done on diesel engines.
What are the common problems of the Egea 1.3 Multijet 95?
The best-known problems are: DPF clogging, EGR valve failure, Timing chain stretch. The symptoms and fix for each are explained on this page.
Other Fiat models
Values are approximate and may vary by engine and VIN. Check against your service manual before doing any work. ·