Fiat · Fiorino (225) · 2008-2023
Fiat Fiorino 1.3 Multijet 75 specs and common problems
A small commercial vehicle built in Turkey and used by tradespeople more than any other. The chain-driven 1.3 Multijet is economical. With heavy loads and city use, DPF and clutch maintenance come to the fore.
01 / 07
How much oil does the Fiorino 1.3 Multijet 75 take?
The Fiorino 1.3 Multijet 75 takes about 3.9 litres of 5W-30 engine oil including the filter. Approval to look for on the bottle: Fiat 9.55535-S1 / ACEA C2.
- Approval
- Fiat 9.55535-S1 / ACEA C2
- Alternative
- 0W-30
- Manual 5-speed
- 75W-85 · ≈ 1.8 L
- Coolant
- Paraflu (OAT) 50/50 · ≈ 6 L
- Brake fluid
- DOT 4
The value may vary by engine version; check with the dipstick.
02 / 07
Timing chain and maintenance
No replacement interval; replaced when stretch symptoms appear
A rattle on cold start signals chain stretch.
- Oil change
- 15,000 km or once a year (10,000 km with DPF)
- Glow plug
- 4 pcs · When they fail
- Valves / tappets
- Hydraulic tappets.
- Fuel filter
- 30,000 km
- Power
- 75 hp @ 4,000 rpm
- Torque
- 190 Nm @ 1,750 rpm
- Displacement
- 1,248 cc
- Fuel
- Diesel · Variable geometry turbo, intercooler
- Valvetrain
- DOHC 16V
- Injection
- Common-rail direct injection
- Transmission
- 5-speed manual
- Emissions
- Euro 5 (DPF)
03 / 07
Tyre size and pressure
- Original size
- 185/65 R15
- Alternative sizes
- 175/70 R14
- Bolt pattern (PCD)
- 4x98
- Centre bore
- 58.1 mm
- Wheel
- 6J x 15
04 / 07
Is the Fiorino 1.3 Multijet 75 suitable for LPG?
- Classic LPG conversions are not done on diesel engines.
05 / 07
Fiorino 1.3 Multijet 75 common problems and fixes
- #01
DPF clogging
High RiskAfter 60,000 km (earlier in the city)
- Symptom:
- DPF warning, loss of power, oil level rising.
- Cause:
- Regeneration being interrupted on short trips.
- Proper fix:
- Motorway driving or service regeneration, DPF cleaning if needed.
- #02
EGR valve failure
Medium RiskAfter 80,000 km
- Symptom:
- Rough idle, limp mode, P0401.
- Cause:
- Soot build-up.
- Proper fix:
- EGR cleaning or replacement.
- #03
Timing chain stretch
High RiskAfter 180,000 km
- Symptom:
- Rattle when cold, hard starting, P0016.
- Cause:
- Long oil change intervals and a worn tensioner.
- Proper fix:
- The chain kit and tensioner are replaced.
06 / 07
Common fault codes on the Fiorino 1.3 Multijet 75
- P2002Diesel Particulate Filter Efficiency Below Threshold (Bank 1)
- P0401Exhaust Gas Recirculation Flow Insufficient Detected
- P0087Fuel Rail/System Pressure - Too Low
- P0380Glow Plug/Heater Circuit A Malfunction
- P0016Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor A)
- P0700Transmission Control System Malfunction
07 / 07
Frequently asked questions
How much engine oil does the Fiorino 1.3 Multijet 75 take?
The Fiorino 1.3 Multijet 75 (1.3 Multijet) takes about 3.9 litres of engine oil including the filter. Recommended viscosity is 5W-30; look for the Fiat 9.55535-S1 / ACEA C2 approval. Check the level on the dipstick after filling.
When should the timing chain on the Fiorino 1.3 Multijet 75 be replaced?
This engine uses a timing chain. No replacement interval; replaced when stretch symptoms appear. A rattle on cold start signals chain stretch.
What tyre pressure should the Fiorino 1.3 Multijet 75 run?
With the original 185/65 R15 tyres, 36 PSI front and 42 PSI rear are recommended at normal load, and 38 front / 46 rear at full load. The exact values are on the door pillar or fuel flap sticker.
Is the Fiorino 1.3 Multijet 75 suitable for LPG?
Not suitable, diesel engine. Classic LPG conversions are not done on diesel engines.
What are the common problems of the Fiorino 1.3 Multijet 75?
The best-known problems are: DPF clogging, EGR valve failure, Timing chain stretch. The symptoms and fix for each are explained on this page.
Other Fiat models
Values are approximate and may vary by engine and VIN. Check against your service manual before doing any work. ·